​TS2017 Raildriver and Joystick Interface

  • Uploaded on behalf of Cobra One


    TS2017 Raildriver and Joystick Interface V3.2.9 released

    1. Adjusted the code so that more sifa / cruise control commands can be displayed on the rail driver or sent through the serial port.

    2. It is now possible to use the hat switch on a joystick as 4 separate buttons.

    3. Added the option to now split the axis of a joystick into two when assigning it as a button which means, one end of travel can be one button and the other end can be a second button. See page 8 of the manual. As a result, you can now use your flight sticks as buttons too.

    An example of it's use would be as the brake lever on a class 66 which is center sprung. Assign the apostrophe key to the down side of the axis and the semicolon to the up side of the axis.

    You will need to first add a new command for this see page 8 section 4e.

    Another option would be to assign the space key to the left side of the axis and the B key to the right side to give you the high / low horn.


    TS2017 Raildriver and Joystick Interface V3.2.9 released

    1. Added script fixes for both the Clinchfield and Wasatch EMD F7's (Thanks to Graham)

    2. Removed the option to split the levers when assigning levers as this only applies when assigning the lever as buttons.

    3. Improved detection of the Rx, Ry, Rz and sliders on axis joysticks When assigning them.

    Teaser
    Software to allow use of one or more Raildrivers and or joysticks. Will also allow the use of home built interfaces.
    Lizenz
    keine
    Sprache
    EN
    Version
    3.2.7

    Dateien

Teilen

Kommentare 1

  • Hallo Holzroller

    Vielen Dank für diese tolle Schnittstelle. Ich erstelle damit aktuell für den ABe 4/4 iii der Rhätischen Bahn (St. Moritz - Tirano) einen Raildriver mittels Arduino. Ich hatte bis jetzt nur wenige Probleme und kann so alle Informationen vom Simulator erhalten sowie auch Befehle an den Simulator senden. Und dies bis jetzt sehr zuverlässig.


    Ich hoffe dass die Software noch lange Up to Date gehalten wird


    Lg CraftoMia

Support Kommentar 2

  • Thanks to MaxCook I have uploaded a fix for the R49 stock on the Virtual District Line, it consists of a new Controlnames.txt file which need to be placed in your Settings folder and a new lever map which need to be placed in
  • Hallo Holzroller
    Vielen Dank für diese tolle Schnittstelle. Ich erstelle damit aktuell für den ABe 4/4 iii der Rhätischen Bahn (St. Moritz - Tirano) einen Raildriver mittels Arduino. Leider stehe ich aktuell vor einigen Problemen bei den seriellen…